Volume 37 Issue 1
Feb.  2020
Turn off MathJax
Article Contents
LI Qiang, LI Zhiyong, ZHANG Haodong, SUN Hansen, LI Linyuan, LI Xingang, WANG Yue. Study on Foam Drilling Fluid Stabilized with Nanomaterials Optimized with RSM[J]. DRILLING FLUID & COMPLETION FLUID, 2020, 37(1): 23-30. doi: 10.3969/j.issn.1001-5620.2020.01.004
Citation: LI Qiang, LI Zhiyong, ZHANG Haodong, SUN Hansen, LI Linyuan, LI Xingang, WANG Yue. Study on Foam Drilling Fluid Stabilized with Nanomaterials Optimized with RSM[J]. DRILLING FLUID & COMPLETION FLUID, 2020, 37(1): 23-30. doi: 10.3969/j.issn.1001-5620.2020.01.004

Study on Foam Drilling Fluid Stabilized with Nanomaterials Optimized with RSM

doi: 10.3969/j.issn.1001-5620.2020.01.004
  • Received Date: 2019-08-29
  • Publish Date: 2020-02-28
  • Nanomaterials have been used to improve the stability of foam drilling fluids, and the effects of the wettability of the nanomaterials on the foam quality were studied using three-factor three-level response surface methodology (RSM) in accordance with the Box-Behnken Design principle. In the studies the concentrations of the foaming agent BS-12, the hydrophilic nanoSiO2 and the viscosifier XC were optimized, and the effects of their interaction on the comprehensive performance of the foam were investigated. A new foam drilling fluid was designed based on these studies. It was found in the studies that the wettability of the nanomaterials remarkably affected the foam quality of the foaming agents. Hydrophobic nanomaterials was able to enhance the stability of the foam produced with an ionic foaming agent SDS. Increased treatment of the hydrophobic nanomaterials decreased the foam quality and halflife of the foam produced with an amphoteric foaming agent BS-12. The optimized foam mud was obtained using RSM design, which is: 0.6%BS-12 + 4%Nano SiO2+0.3%XC. RSM analysis showed that order of magnitude of effect of the concentrations of the three agents on the comprehensive performance of the foam is: nanomaterial > foaming agent > XC. Laboratory evaluation showed that this foam drilling fluid had apparent viscosity of 42 mPa·s, density of 0.81 g/cm3, half life of 60 h, meaning that the foam drilling fluid is able to sustain its stability for a long time. The foam drilling fluid also showed strong shale inhibitive capacity; the linear expansion rate is 65% lower than that of clean water. The recovery rate of coal rock core gas permeability is over 90%, and settling velocity of rock and coal cuttings in the foam drilling fluid was reduced by at least 92% compared with clear water, indicating that the foam drilling fluid had both good reservoir protection performance and good cuttings carrying capacity. The results of the performance evaluation test showed that this foam drilling fluid is able to satisfy the needs of coal-bed methane drilling.

     

  • loading
  • [1]
    徐加放,邱正松,何群.可循环微泡沫钻井液的防塌机理及应用研究[J].钻井液与完井液, 2010, 27(4):7-9.

    XU Jiafang, QIU Zhengsong, HE Qun. Anti collapse mechanism and application of recyclable micro foam drilling fluid[J]. Drilling Fluid&Completion Fluid, 2010, 27(4):7-9.
    [2]
    PORTER, M, HILL A, VIEIRA P, et al. Optimizing the application of underbalanced drilling through the use of air and foam systems in low-pressure gas reservoirs[C]//SPE/IADC Middle East Drilling Technology Conference and Exhibition-Abu Dhabi, UAE, 2018.
    [3]
    GROWCOCK F, SIMON G, REA A, et al. Alternative aphron-based drilling fluid[C]//Society of Petroleum Engineers IADC/SPE Drilling Conference, Dallas, Texas, 2004.
    [4]
    姚金星,万里平,高攀明,等.聚合物纳米组装微泡沫钻井液体系及其性能评价[J].石油钻采工艺, 2018, 40:577-581. YAO Jinxing, WAN Liping, GAO Panming, et al.Polymer nano assembly micro foam drilling fluid system and its performance evaluation[J]. Oil Drilling&Production Technology, 2018

    , 40:577-581.
    [5]
    赵雄虎,高飞,鄢捷年,等.纳米钻井液材料GY-2室内研究[J].油田化学, 2010, 27:357-359, 365.

    ZHAO Xionghu, GAO Fei, YAN Jienian, et al. Laboratory study on nano drilling fluid material GY-2[J]. Oilfield Chemistry, 2010, 27:357-359, 365.
    [6]
    光新军,豆宁辉,贾云鹏,等.纳米技术在石油工程中的应用前景[J].钻采工艺, 2019, 42:34-37, 38.

    GUANG Xinjun, DOU Ninghui, JIA Yunpeng, et al. Application prospect of nanotechnology in petroleum engineering[J]. Drilling&Production Technology, 2019, 42:34-37, 38.
    [7]
    彭宝亮,罗健辉,王平美,等.用于低渗透油田调剖的纳米颗粒稳定泡沫体系研究进展[J].油田化学, 2017, 34:745-748. PENG Baoliang, LUO Jianhui, WANG Pingmei, et al. Research progress of nanoparticle stabilized foam system for profile control in low permeability oilfield[J]. Oilfield Chemistry, 2017

    , 34:745-748.
    [8]
    LAKSHMI M D, RAJPUT G, PANDYA N, et al. Enhanced foam ability and foamst a bility of polyoxyethylene cholesteryl ether in occurrence of ionic surfactants[J]. Colloids and Surfaces A:Physicochemical and Engineering Aspects, 2018, 551:81-86.
    [9]
    赵江玉,蒲万芬,李一波,等.耐高温高盐泡沫体系筛选与性能评价[J].天然气与石油, 2014, 32:65-69. ZHAO Jiangyu, PU Wanfen, LI Yibo, et al. Screening and performance evaluation of high temperature and high salt foam system[J]. Natural Gas and Oil, 2014

    , 32:65-69.
    [10]
    赵国玺.表面活性剂化学[M].北京:北京大学出版社, 1984. ZHAO Guoxi. Surfactant chemistry[M]. Beijing, Peking University Press, 1984.
    [11]
    ZHANG S, LAN Q, LIU Q, et al. Aqueous foams stabilized by Laponite and CTAB[J]. Colloids&Surfaces A Physicochemical&Engineering Aspects, 2008, 317:406-413.
    [12]
    孙乾,李兆敏,李松岩,等. SiO2纳米颗粒稳定的泡沫体系驱油性能研究[J].中国石油大学学报(自然科学版), 2014:124-131. SUN Qian, LI Zhaomin, LI Songyan, et al. Study on oil displacement performance of SiO2 nanoparticle stabilized foam system[J]. Journal of China University of Petroleum (Edition of Natural Science), 2014:124-131.
    [13]
    黄晋,孙其诚.液态泡沫渗流的机理研究进展[J].力学进展, 2007:269-278. HUANG Jin, SUN Qicheng. Research progress in the mechanism of liquid foam seepage[J]. Advances in Mechanics, 2007:269

    -278.
    [14]
    宋水祥,罗溪梅,马鸣泽,等.泡沫稳定性研究进展[J].矿冶, 2019, 28:30-34. SONG Shuixiang, LUO Ximei, MA Mingze, et al. Research progress of foam stability[J]. Mining and Metallurgy, 2019

    , 28:30-34.
    [15]
    李莉,张赛,何强,等.响应面法在试验设计与优化中的应用[J].实验室研究与探索, 2015, 34:41-45. LI Li, ZHANG Sai, HE Qiang, et al.Application of response surface methodology in experimental design and optimization[J]. Research and Exploration in Laboratory, 2015

    , 34:41-45.
    [16]
    BOX G E P, WILSON K B J R. On the experimental attainment optimum conditions[J]. Stat, 1951, 13(1):1-45.
    [17]
    李靖嵩,曹静,周明,等. CR052111/APP-4二元泡沫体系的室内研究[J].钻采工艺, 2015, 38:91-94, 96.

    LI Jingsong, CAO Jing, ZHOU Ming, et al. Laboratory study on binary foam system APP-4/CR052111[J]. Drilling&Production Technology, 2015, 38:91-94, 96.
    [18]
    KHATAEE A R, DEHGHAN G. Optimization of biological treatment of a dye solution by macroalgae Cladophora sp. using response surface methodology[J]. Journal of the Taiwan Institute of Chemical Engineers, 2011, 42:26-33.
    [19]
    尹少华,林国,彭金辉,等.响应曲面法优化微波干燥碳酸稀土的实验研究[J].稀有金属, 2016, 40, 350-355. YIN Shaohua, LIN Guo, PENG Jinhui, et al. Experimental study on microwave drying of Rare earth carbonate by response surface methodology[J]. Rare Metals, 2016

    , 40:350-355.
    [20]
    李宾飞,黄梦梅,李兆敏,等.泡沫性能综合评价实验设计[J].实验技术与管理, 2017, 34:187-190. LI Binfei, HUANG Mengmei, LI Zhaomin, et al. Experimental design of foam performance comprehensive evaluation[J]. Experimental Technology and Management, 2017

    , 34:187-190.
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索

    Article Metrics

    Article views (582) PDF downloads(143) Cited by()
    Proportional views
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return