Study on the Performance of SSMA-A Thinner Made Through Mass Polymerization
-
摘要: 为探究本体聚合法合成的磺化苯乙烯-马来酸酐(SSMA)在水基钻井液中降黏性能的优劣,以苯乙烯(St)、马来酸酐(MA)为原料,分别采用本体聚合和溶液聚合制得苯乙烯-马来酸酐(SMA),磺化后制得SSMA,并对不同方法制得的磺化苯乙烯-马来酸酐(SSMA)在钻井液中的降黏效果和抗温抗盐性能进行评价。结果表明,2种方法合成的SSMA都可有效地拆散钻井液中黏土颗粒形成的空间网状结构,但在盐水和高温条件下2者表现出不一样的降黏效果。①在淡水基浆中,2者均表现出好的降黏效果,当加量达到0.75%时,本体聚合制得的SSMA在淡水基浆中降黏率可达95.38%,溶液聚合制得的SSMA在基浆中的降黏率为85.54%。②在盐水基浆中,与溶液聚合制备的SSMA相比,本体聚合制备的SSMA的降黏作用更强,具有更好的抗盐性能,当加量达到1%时,其降黏率可达53.33%。③在高温老化实验中,本体聚合制得的SSMA在基浆中的降黏性能较溶液聚合制得的SSMA受高温影响较小,在老化温度为230℃时,仍可保持40%以上的降黏率,具有更好的抗温性能。④在高密度基浆中,本体聚合法制备的SSMA具有较高的降黏率,220℃老化后降黏率仍在60%以上,高于溶液聚合法制备的SSMA在高密度基浆中47.45%的降黏率。Abstract: Mass polymerization and solution polymerization were used to prepare styrene-maleic anhydride (SMA) with styrene (St) and maleic anhydride (MA). The two SMAs made were then sulfonated to sulfonated styrene-maleic anhydride (SSMA). SSMAs made from the two methods were evaluated for their abilities in drilling fluids to reduce viscosity and to resist the effects of high temperature and salt contamination. It was found that the two SSMAs made both can effectively tear apart the spatial networking structure formed by the clay particles in the drilling fluid. In saltwater muds and at high temperatures, the two SSMAs performed differently in viscosity reduction. First, in fresh water base drilling fluids, the two SSMAs both can reduce mud viscosity efficiently. At a concentration of 0.75%, the SSMA made through mass polymerization can reduce the viscosity by 95.38%, while the SSMA made through solution polymerization can reduce the viscosity by 85.54%. Second, in saltwater drilling fluids, the SSMA made through mass polymerization had better viscosity reduction ability and better salt resistance. At a concentration of 1%, the viscosity of saltwater drilling fluids can be reduced by 53.33% by the SSAM made through mass polymerization. Third, in aging experiments at elevated temperatures, the viscosity reducing performance of the SSMA made through mass polymerization was less affected by temperature than that of the SSMA made through solution polymerization. After aging at 230℃, the rate of viscosity reduction (by the SSMA made through mass polymerization) was still maintained at 40% or higher. Fourth, in high density drilling fluids, SSAM made through mass polymerization had higher rate of viscosity reduction. After aging at 220℃, the rate of viscosity reduction was still maintained at 60% or higher, higher than the rate of viscosity reduction of SSMA made through solution polymerization, which was 47.45% in high density drilling fluids.
-
[1] MAHTO V,SHARMA V P. Rheological study of a water based oil well drilling fluid[J]. Journal of Petroleum Science & Engineering,2004,45(1):123-128. [2] 鄢捷年. 钻井液工艺学[M]. 北京:中国石油大学出版社,2003:57-73. YAN Jienian.Drilling fluid technology[M].Beijing:China university of petroleum press,2003:57-73. [3] 欧阳坚,朱卓岩,王贵江,等.TS系列新型抗温抗盐聚合物的研究[J]. 石油勘探与开发,2003,30(2):79-81.OU Yangjian,ZHU Zhuoyan,WANG Guijiang,et al. Research on the high temperature and salt resistance (TS series)polymers[J].Petroleum Exploration and Development,2003,30(2):79-81. [4] 刘立新,杜俊涛,刘顺平,等. 耐高温钻井液降黏剂St/AMPS/AA的研制[J]. 钻井液与完井液,2012,29(2):18-20.LIU Lixin, DU Juntao, LIU Shunping,et al.Research on high temperature drilling fluid thinner St/AMPS/AA[J]. Drilling Fluid & Completion Fluid,2012, 29(2):18-20. [5] 谢建宇,王旭,张滨,等.AA/AMPS/DMDAAC共聚物钻井液降黏剂性能评价[J]. 石油与天然气化工, 2009,38(5):434-436.XIE Jianyu, WANG Xu, ZHANG Bin, et al. Properties of AA/AMPS/DMDAAC copolymer as viscosity reducer for drilling fluids[J].Chemical Engineering of Oil and Gas,2009,38(5):434-436. [6] HUANG W,ZHAO C,QIU Z,et al.Synthesis characterization and evaluation of a quadripolymer with low molecular weight as a water based drilling fluid viscosity reducer at high temperature (245℃)[J]. Polymer International,2015,64(10):1352-1360. [7] HAI B,SUN J,WANG C,et al.Rheological properties of polymer-gel drilling fluids at high temperature and pressure[J].Chemistry and Technology of Fuels and Oils, 2013, 48(6):449-458. [8] 李骑伶,赵乾,代华,等. 对苯乙烯磺酸钠/马来酸酐/木质素磺酸钙接枝共聚物钻井液降黏剂的合成及性能评价[J]. 高分子材料科学与工程,2014,30(2):72-76.LI Qiling,ZHAO Qian,DAI Hua,et al.Synthesis and characterization of calcium lignosulfonate grafted with p-styrenesulfonate and maleic anhydride[J].Polymer Materials Science and Engineering,2014,30(2):72-76. [9] 李骑伶,叶德展,刘侨,等.SSMA和AMA对钻井液降黏作用效果研究[J]. 油田化学, 2013, 30(1):5-10.LI Qiling,YE Dezhan,LIU Qiao,et al.Effect of SSMA and AMA on reducing the viscosity of drilling fluid[J].Oifiled Chemistry,2013,30(1):5-10. [10] 李小华,强西怀,洪新球. 苯乙烯-马来酸酐共聚物及应用[J]. 皮革科学与工程,2009,19(2):42-46.LI Xiaohua,QIANG Xihuai,HONG Xinqiu,et al. Polymer of styrene-maleic anhydride and its application evolvement[J].Leather Science and Engineering,2009, 19(2):42-46. [11] 唐炳涛,赵杰,张淑芬,等. 苯乙烯-马来酸酐交替共聚物合成及表征[J]. 大连理工大学学报,2011,51(3):326-330.TANG Bingtao,ZHAO Jie,ZHANG Shufen,et al. Synthesis and characterization of styrene-maleic anhydride alternating copolymers[J].Joural of Dalian University of Technology,2011,51(3):326-330. [12] 周玲. 磺化苯乙烯-马来酸酐共聚物的合成及其性能研究[D]. 南京理工大学,2007. ZHOU Ling.Synthesis and properties of sulfonated styrene-maleic anhydride copolymer[D].Nanjing University of Science and Technology,2007. [13] 樊泽霞,王杰祥,孙明波,等. 磺化苯乙烯-水解马来酸酐共聚物降黏剂SSHMA的研制[J]. 油田化学, 2005,22(3):195-198.FAN Zexia,WANG Jiexiang,SUN Mingbo,et al. Preparation of sulfonated styrene/hydrolyzed maleic anhydride copolymer sshma as viscosity reducer for drilling fluid[J].Oifiled Chemistry,2005,22(3):195-198. [14] 张洪利,冯晓宁,赵再见,等. 苯乙烯-马来酸酐聚合物/半焦复合材料的研究[J]. 应用化工,2013,42(11):2012-2014.ZHANG Hongli,FENG Xiaoning,ZHAO Zaijian,et al. Research of styrene-maleic anhydride polymer/semi-coke composite technology[J].Processapplication of Chemical, 2013,42(11):2012-2014. [15] 张春雨,董博,张贺新,等. 本体共聚合制备丙烯/1-丁烯合金及表征[J]. 高等学校化学学报,2014, 35(9):2014-2018.ZHANG Chunyu,DONG Bo,ZHANG Hexin,et al. Preparation and characterization of propylene/1-butene alloy with bulk copolymerization[J].Chemical Journal of Chinese Universities,2014,35(9):2014-2018. [16] 潘祖仁. 高分子化学(第四版)[M]. 北京:化学工业出版社, 2007:146-147. PAN Zuren.Polymer Chemistry[M].Beijing:Chemical Industry Press,2007:146-147. [17] SY/T 5243-91,水基钻井液用降黏剂评价程序[S]. SY/T 5243-91,evaluation procedure of viscosity reducer for water-based drilling fluids[S]. [18] 孟季茹,梁国正,赵磊,等, 苯乙烯-马来酸酐无规共聚物的合成方法及其增容作用[J]. 中国塑料,2001, 15(10):40-44.MENG Jiru, LIANG Guozheng, ZHAO Lei, et al. Synthesis of random SMA and its compatibization[J]. China Plastics,2001,15(10):40-44. [19] 黄源. 橡胶接枝苯乙烯-马来酸酐无规本体共聚合过程的研究[D]. 浙江大学,2003. HUANG Yuan.Studies on grafting copolymerization of styrene and maleic anhdyride onto rubber[D]. ZhejiangUnviersity,2003. [20] 匡韶华,蒲晓林,柳燕丽. 高密度钻井液稳定性和流变性控制技术[J]. 钻井液与完井液,2011,28(3):5-8.KUANG Shaohua,PU Xiaolin, LIU Yanli.Study on stability and rheology control techenology of high-density driling fluid[J].Drilling Fluid & Completion Fluid, 2011,28(3):5-8.
点击查看大图
计量
- 文章访问数: 468
- HTML全文浏览量: 148
- PDF下载量: 191
- 被引次数: 0